You have been asked to install and configure a new switch in a customer network. Use the console access to the existing and new switches to configure and verify correct device configuration.

يمكنك استعراض اﻹعدادات بالنقر على اﻷزرار التالية:-

sw1# sh vtp Status
sw2# sh vtp Status
sw2# show interfaces trunk
sw1# show interfaces trunk
sw3# sh vtp Status
1. You are connecting the New_Switch to the LAN topology; the switch has been partially configured and you need to complete the rest of configuration to enable PC1 communication with PC2. Which of the configuration is correct?
2. Refer to the configuration. For which configured VLAN are untagged frames sent over trunk between SW1 and SW2?
3. You are adding new VLANs: VLAN500 and VLAN600 to the topology in such way that you need to configure SW1 as primary root for VLAN 500 and secondary for VLAN 600 and SW2 as primary root for VLAN 600 and secondary for VLAN 500. Which configuration step is valid?
4. Examine the VTP configuration. You are required to configure private VLANs for a new server deployment connecting to the SW4 switch. Which of the following configuration steps will allow creating private VLANs?