ccnp-switch-300-115-cdp-lldp-quiz-1

1. What is the default interval at which Cisco devices send Cisco Discovery Protocol advertisements?

60 seconds

30 seconds

120 seconds

300 seconds

2. Which statement about Cisco Discovery Protocol configuration on a Cisco switch is true?

CDP is disabled by default and can be enabled globally with the command cdp enable.

CDP is disabled by default and can be enabled globally with the command cdp run.

CDP is enabled by default and can be disabled globally with the command no cdp enable.

CDP is enabled by default and can be disabled globally with the command no cdp run.

3. A network engineer notices inconsistent Cisco Discovery Protocol neighbors according to the diagram that is provided. The engineer notices only a single neighbor that uses Cisco Discovery Protocol, but it has several routing neighbor relationships. What would cause the output to show only the single neighbor?

Cisco Express Forwarding is enabled locally.

IP routing is disabled on neighboring devices.

The routers are connected via a Layer 2 switch.

Cisco Discovery Protocol advertisements are inconsistent between the local and remote devices.

4. After the implementation of several different types of switches from different vendors, a network engineer notices that directly connected devices that use Cisco Discovery Protocol are not visible. Which vendor-neutral protocol could be used to resolve this issue?

Local Area Mobility

Link Layer Discovery Protocol

NetFlow

Directed Response Protocol

5. While doing network discovery using Cisco Discovery Protocol, it is found that rapid error tracking is not currently enabled. Which option must be enabled to allow for enhanced reporting mechanisms using Cisco Discovery Protocol?

Cisco Discovery Protocol source interface

. Cisco IOS Embedded Event Manager.

logging buffered.

Cisco Discovery Protocol version 2

Cisco Discovery Protocol logging options

6. A network engineer has just deployed a non-Cisco device in the network and wants to get information about it from a connected device. Cisco Discovery Protocol is not supported, so the open standard protocol must be configured. Which protocol does the network engineer configure on both devices to accomplish this?

LLTD

LLDP

IRDP

NDP

7. Which statement about Cisco devices learning about each other through Cisco Discovery Protocol is true?

Each device sends periodic advertisements to multicast address 01:00:0C:CC:CC:CC.

Each device sends periodic advertisements to all IP addresses in its ARP table.

Each device sends periodic advertisements to a central device that builds the network topology.

Each device broadcasts periodic advertisements to all of its neighbors.

8. Which option lists the information that is contained in a Cisco Discovery Protocol advertisement?

native VLAN IDs, memory errors, hardware platform

native VLAN IDs, port-duplex, memory errors

port-duplex, hardware platform, memory errors

native VLAN IDs, port-duplex, hardware platform

9. Which statement about LLDP-MED is true?

LLDP-MED is an extension to LLDP that operates only between network devices.

LLDP-MED is an extension to LLDP that operates between endpoint devices and network devices.

LLDP-MED is an extension to LLDP that operates between routers that run BGP.

LLDP-MED is an extension to LLDP that operates only between endpoint devices.

10. Which option describes a limitation of LLDP?

LLDP can discover up to two devices per port.

LLDP cannot provide information about VTP.

LLDP does not support TLVs.

LLDP can discover only Windows servers.

Share this:

Like this: