1. An engineer must configure a /30 subnet between two routers. Which usable IP address and subnet mask combination meets this criteria?

Question 1 of 9

2. An office has 8 floors with approximately 30-40 users per floor. What command must be configured on the router Switched Virtual Interface to use address space efficiently?

Question 2 of 9

3. Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?

Question 3 of 9

4. Refer to exhibit. Which statement explains the configuration error message that is received?
Router(config)#interface GigabitEthernet 1/0/1
Router(config-if)#ip address 192.168.16.143 255.255.255.240
Bad mask /28 for address 192.168.16.143

Question 4 of 9

5. Which goal is achieved by the implementation of private IPv4 addressing on a network?

Question 5 of 9

6. A corporate office uses four floors in a building
* Floor 1 has 24 users
* Floor 2 has 29 users
* Floor 3 has 28 users
* Floor 4 has 22 users

 

Which subnet summarizes and gives the most efficient distribution of IP addresses for the router configuration?

Question 6 of 9

7. Refer to the exhibit. An engineer must add a subnet for a new office that will add 20 users to the network. Which IPv4 network and subnet mask combination does the engineer assign to minimize wasting addresses?

Question 7 of 9

8. Which network allows devices to communicate without the need to access the Internet?

Question 8 of 9

9. Which function does the range of private IPv4 addresses perform?

Question 9 of 9